Vent sealing
Cracked vent caps are replaced with a sealant that suits the roof.
A Mountainside roofer can fix leaks on metal, rubber and shingle mobile home roofs, working with the light framing these homes are built on. Dial (908) 728-6030 to talk through the leak with a local roofer.
Leaks on a manufactured home roof tend to follow a predictable pattern. Older single and double wides often have galvanized steel or aluminum roofs on bowed trusses, and newer manufactured homes may have rubber membrane or shingles. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Small leaks spread fast in a mobile home. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. A ceiling sagging with water can be drained through a small hole into a bucket, away from any light fixture, with power to that area shut off at the panel if the panel is safe to reach.
Mobile home roofs are not built to be walked on like a house roof. Stepping between the supports can buckle the metal or damage the ceiling, so roofers stay on the truss lines. Stay off a wet or icy roof, and look for the data plate inside the home, which shows the roof load the home was designed for.
If the problem goes deeper than it first looked, a Mountainside roofer may also recommend roof coating or metal roof repair.
Need mobile home roof repair in Mountainside? Call (908) 728-6030 to reach a nearby roofing contractor.
Call nowA lasting repair seals the roof and deals with any water damage underneath.
The roofer walks the truss lines or works from a ladder, checking seams, fasteners, the perimeter edge and every vent, skylight and curb. Stains on the ceiling inside help narrow down the source.
Backed out fasteners are swapped for new gasketed screws, often a size up so they bite into fresh wood. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Vent caps, skylights and the AC curb get fresh sealant or new flashing, and cracked vent covers are replaced. The perimeter edge where roof meets wall is sealed as well.
Many repairs finish with a roof coating that seals pinholes, protects the metal from rust and keeps the home cooler. The roof must be clean and dry for the coating to stick.
Cracked vent caps are replaced with a sealant that suits the roof.
An elastomeric or silicone coating is applied to keep the home cooler.
Open seams are sealed with tape or fabric and coating so water stops getting through.
Backed out fasteners are swapped to close leaks at every screw.
Water damaged areas are opened and fixed before new roofing goes over them.
Mobile home roof replacement makes sense when the metal has rusted through in many places, the membrane is worn out or the decking and trusses have rotted from years of leaks. Depending on the home, the new roof may be metal, a single ply membrane such as EPDM or TPO, or shingles on a pitched roof. Damaged trusses are fixed first.
For mobile home roof replacement in Mountainside, the roofer has to plan around light framing and the roof load the home was built for. A permit may be required, and rules for manufactured homes can differ from site-built homes, so the roofer should check local requirements. Done right, the new roof should end the cycle of patching.
A roof over leaves the old roof in place and builds a new one on top. Roof overs range from low slope membrane systems over foam board to framed pitched roofs topped with shingles or metal. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
For a Mountainside mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. A good roof over ends the seam and screw leaks that plague old metal roofs.
Around Mountainside, mobile home roofs include older metal roofs, rubber membrane roofs and newer shingle roofs on pitched manufactured homes. From Mountainside out to Westfield, Summit, New Providence and Garwood, most mobile home roof calls come down to seams, screws and sealant around vents, and storms with strong wind are what loosen fasteners and lift edges.
Searching for mobile home roof repair near me from Mountainside or Westfield, Summit, New Providence and Garwood? Call (908) 728-6030 to talk to a roofer who works in your part of town.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Mountainside, NJ have the roof checked in the fall and again after the snow melts.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Mountainside know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (908) 728-6030
Liquid-applied roof coatings that seal seams, reflect heat and add years to a roof, as an option before a full tear-off.
Learn moreMetal roof repairs that stop leaks at the screws, laps and flashing, without replacing panels that are still sound.
Learn moreEPDM rubber roof repairs done with primer, cover tape and lap sealant made for rubber, after the real leak point is found.
Learn moreFinding where water gets through the roof and sealing it at the source, with the damage underneath checked too.
Learn moreLooking for something else?
See all roofing servicesCall now for Mountainside mobile home roof repair and help in the towns around it.